Hackintosh Build.. Success

Since last night I had been toying around with my PC to install hackintosh. After 5 hours of work I had successfully installed it. Every component is working as it should be. However, I just couldn't launch FCP X and Motion 5. Launching them always result in ".. cannot be opened because of a problem.." blah blah blah.

Update: Finally got both FCPX and Motion 5 to work after performing Software Update. I think ProRes Kit is the needed things here. Now all runs well :-D

I had posted a thread here on tonymac here in hope that someone will shed a light to me.

This guide by Jeff works as charm. Just follow it if you have similar build as his. The only thing different between my build and his is my graphic card and I'm using TP Link wireless USB dongle. Took me quite a while to find the proper kext for the dongle. Glad that the effort of searching prove to be worthwhile.

Screenshots:

It should be 1600 MHz, well I guess losing 80Mhz wouldn't hurt the performance.

Hehe, Mac Pro, or Hack Pro?


Graphic card detected alright. Too bad I still can't output audio via HDMI interface.

Ralink (TP-WN321G) Airport Interface

---

The following links should guide you on how to install the Ralink kext on your hackintosh.

http://www.insanelymac.com/forum/index.php?showtopic=163067
http://www.projectosx.com/forum/index.php?showtopic=390&mode=threaded&pid=4230
http://www.insanelymac.com/forum/index.php?showtopic=170442

---

Additional Info
How to Remove Kext File

1 comments:

I just read your article and I'm glad that you have successfully installed Mac Os on your laptop. Well, if someone is looking to build a hackintosh laptop for gaming then it is recommended to take a look at this list of graphics cards for hackintosh where you can find the best graphics card to install in your laptop. I bet you will find the best one for your needs on this link.

Reply

Post a Comment

If you found this article or post helpful to you, feel free to enter your comments below ;)